iPhone 6s Lightning Connector and HeadphoneJack Repair Warning: You are performing this repair at your ownrisk We claim no responsibility for any damagesthat might occur To perform this DIY repair, you will needa – Small Phillips Screwdriver (Item # 5-0016,Available at www.
Com) iPhone 5-Point Pentalobe Screwdriver (Item# 5-0769, Available at www.
Com) iSesamo Opening Tool (Item # 5-1451, Availableat www.
Com) Suction Cup (Item # 5-0020, Available at www.
Com)Fine Tip Curved Tweezers (Item # 5-1370, Available at www.
Com) Power down your iPhone 6s.
Remove the two bottom 3.
4 mm Pentalobe screwslocated next to the lightning connector.
Place a suction cup near the home button andpull the display assembly away from the rear case.
Use the iSesamo opening tool to slicethrough the adhesive and help carefully separate the display assembly from the rear case.
Take your time and apply firm, constant force.
The display assembly is a much tighter fit than most devices and is held down with adhesive.
The display assembly is still connected tothe iPhone by several cables, so don’t try to remove it entirely just yet.
Remove the following 4 Phillips screws securingthe metal bracket to the motherboard.
Now use the fine tip curved tweezers to removethe metal bracket and disconnect the LCD, digitizer and front camera and proximity sensorcables.
Remove the following 2 Phillips screws thatsecure the Taptic Engine to the rear case.
With the fine tip curved tweezers remove theiPhone 6s Taptic Engine.
Remove the following 2 Phillips screws thatsecure the protective metal bracket in place.
Detach the battery, lightning connector assembly,and signal cable from the motherboard.
Remove the following 5 Phillips screws securingthe iPhone 6s loudspeaker to the rear case.
With the loudspeaker set aside, remove thefollowing 8 Phillips screws that secure the lightning connector and headphone jack inplace.
With some assistance from the spudger, removethe Lightning Connector and Headphone Jack Assembly from the iPhone 6s.