Com presented iPhone 6SPlus screen replacement please read the following warning before attempting thisrepair you are doing this repair at your own risk using a pentalobe screwdriver from directfix.

Com remove the two pentalobe screws from the bottom of the phone using a suction cup and a case openertool from directfix.

Com but the suction cup on top of the screenand lift the screen up you'll need to use the case opener tool to separate theadhesive from the screen to be able to lift it up lifted up to a 90 degree angle but nofurther using a Phillips screwdriver number double zero from directfix remove the five screws to remove the shield keep track of this screws they aredifferent sizes here is a diagram showing you the five screws need toremove from the shield now that the screws are removed you cannow remove the shield plate we're now going to start to remove threeribbon cables from the screen using a plastic tool pop the ribbon cables up inthe order that you see on the screen first the front one than the one on theright then there will be one hidden underneath the very first front cablewe will point it out here in a second that's the one right there make sure youpop that one up too.

be careful not to rip any of the ribbon cables with the cables removed you can now lift the screen there is adhesive at the top so be careful check the link below we will have aseparate video showing you how to move the replacement parts over from thescreen to the new screen since many of them do not include home buttons andother parts make sure you do not separate the adhesive and it stays withthe bottom of the phone and not the screen.

This adhesive may also be awaterproof adhesive to help keep the phone from getting wet your now going to reconnect the cablesgoing in reverse order first the cable that was hiddenunderneath then the one on the right then the one on the front they justpress down and sometimes you will even here then click into place with the three cables in place your nowgoing to reinstall the shield again here is the diagram showing youwhere the five screws are located put them back in order now you're goingto bring the screen back down and you're going to have to line up the edges to beable to put it back in place make sure that the screen pops intoplace and goes all the way in and be sure to check all the way around thescreen is flush before going on to the next step of installing screws with thescreen sealed all the way down reinstall the pentalobe screws on thebottom don't over tighten the pentalobe screwson the bottom go ahead and turn the device on your alldone with replacing the screen on the iPhone 6S Plus for all parts and accessory needs pleasego to our website directfix.

Com also be sure to click on the screen tosubscribe to our YouTube channel.

Source: Youtube