Alright, today we’re going to take apartthe Samsung Galaxy Light.
It’s kind of a lower end smart phone from Samsung.
Go aheadand take out the back, the battery, the SIM card.
And then there are nine screws aroundthe outside.
Once you have all of those screws out you can just kind of grab on the littleplastic edge and lift that up.
There’s just a series of clasps around the back that holdit to the front of the phone.
Here you can see the loud speaker and the two little contactpoints that just sit on top of the motherboard.
Pretty cool the way that works.
Now you havethe, there’s a little ribbon connector that just unsnaps like a Lego up at the top.
Andthen once that’s off you can fold the motherboard back and see the little connector on the bottomthat goes to the LCD.
Same thing with this one.
It’s like a little Lego, just unsnapit and that releases the motherboard for you.
Now the back camera is connected via a latchconnector, so you just lift up the little latch and then the camera can slide out.
Supereasy to replace.
Put the camera back in, and then you can re-latch it.
Just clip it backdown and that holds it pretty snug.
When I pulled out the motherboard my front camerawas left in the phone so I’m just going to go ahead and slide that back into placeas well so when I put the motherboard back in it’s going to be ready to go.
Just latchit back into place just like you did the rear camera.
Now the charging port and the SIMcard slot are soldered onto the main board, kind of a bummer that they’re not replaceablebut, you know, it’s a low end phone.
Now this is the vibrator motor, the ear pieceand the headphone jack.
Pretty simple to pull out and replace as well.
This is the screen.
If you’re going to replace just the glass watch one of my Galaxy S3, S4, or Galaxy S5replacement videos.
I do not recommend replacing just the glass because the success rate isso low.
But you know, watch those videos and see if you have the desire to complete thatrepair after you’re done.
They’re pretty complicated.
Anyway, I’m going to go aheadand put all of the components back in again, clipping on the motherboard to the LCD, andthen making sure none of the little wire cables are pushed underneath the board so they’renot pinched or anything like that.
Anyway, overall a relatively simple phone to repair.
I would recommend, you know, if you have to fix the screen you can go ahead and try theglass repair otherwise try to do a whole LCD swap.
It just kind of depends on what yourbudget is.
With a phone like this, you know, you don’t have a whole lot to lose.
Anyway,don’t forget to subscribe to my videos, follow me on Instagram @ZacksJerryRig.
Thanksfor watching! I put up videos about every week.